WHAT TO DO IN AN EMERGENCY
D060E01A-AAT
D060F02E-AAT
D060G02Y-AAT
4.
Put the Jack in Place
5. Raising the Car
6. Changing Wheels
Wrench bar
Wheel nut wrench
HGK186
HFC4022
HGK232
The base of the jack should be placed on firm,
level ground. The jack should be positioned as
shown in the drawing.
After inserting a bar into the wheel nut wrench,
install the bar into the jack as shown in the
drawing. To raise the vehicle, turn the jack
handle clockwise. As the jack begins to raise
the vehicle, double check that it is properly
positioned and will not slip. If the jack is on soft
ground or sand, place a board, brick, flat stone or
other object under the base of the jack to keep
it from sinking.
Loosen the wheel nuts and remove them with
your fingers. Slide the wheel off the studs and
lay it flat so it cannot roll away. To put the wheel
on the hub, pick up the spare tire, line up the
holes with the studs and slide the wheel onto
them. If this is difficult, tip the wheel slightly and
get the top hole in the wheel lined up with the
top stud. Then jiggle the wheel back and forth
until the wheel can be slid over the other studs.
Raise the car high enough so that the fully
inflated spare tire can be installed. To do this,
you will need more ground clearance than is
required to remove the flat tire.
WARNING:
Do not get under the car when it is support-
ed by the jack! This is very dangerous as the
jack could fall and cause serious injury or
death. No one should stay in the car while
the jack is being used.
3-6
| Categories | Hyundai Manuals, Hyundai Tiburon Manuals |
|---|---|
| Tags | Hyundai Tiburon 2.0, Hyundai Tiburon 2.7 |
| Model Year | 2003 |
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Tiburon |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(2 votes, average: 4.5 out of 5)
Automotive readers have rated 2003 Hyundai Tiburon Owners Manual 4.5 out of 5.0 based on 2 product reviews. thanks