ASSEMBLY INSTRUCTIONS
NOTE: Before setting up your cultivator / edger, disconnect
ADJUSTING TINE DEPTH
To adjust the wheel support bracket proceed as follows:
the spark plug wire from the spark plug.
POSITIONING THE HANDLEBARS
1.
Stop engine and disconnect spark plug to avoid accidental
starting.
1.
Loosen the two knobs on the inside of the handlebars (Fig. 1).
2.
Remove cotter pin from the clevis pin and slide clevis pin
out of tailpiece bracket (Fig. 3).
Handlebars
Clevis Pin
Bolt
Handlebar
Knob
Cotter Pin
Hole
Washer
Fig. 1
Wheel
Support
2.
With the unit upright, swing the handlebars up into the
operating position (Fig. 2).
Bracket
Tailpiece Bracket
Fig. 3
3.
4.
Slide the wheel support bracket up or down in the tailpiece,
aligning the holes to the desire height.
Place the clevis pin through the hole and secure with cotter pin.
ATTACHING THE EDGER WHEEL AND BLADE
To convert the cultivator to an edger proceed as follows:
1.
Push the On/Off switch to Off (O) position to stop engine and
tines and disconnect spark plug to avoid accidental starting.
NOTE: It may be necessary to lay the cultivator / edger back in
a horizontal position on a flat level surface with the
upper handle touching the ground.
2.
Remove the click pin from each end of the tine shaft and
slide the tines off the shaft.
3.
Slide the edger wheel, with the hub facing inward, onto the
right side of the tine shaft and secure with the click pin in
the inside hole (Fig. 4).
Edger Guide
Line
Fig. 2
NOTE: Take care not to pinch the throttle cable or switch
wires when positioning the handlebar.
3.
Tighten the knobs to secure the handlebars in place.
NOTE: Do not over-tighten the knobs.
Reconnect the spark plug wire to the spark plug.
Hub
4.
Edger Wheel
Tine Shaft
Edger Blade
Click Pin
Fig. 4
4.
5.
Slide the edger blade with the hub facing out onto the left
side of tine shaft and secure with the click pin in the inside
hole (Fig. 4).
The edger guide line indicates where cutting will occur.
Guide the unit along a flowerbed, sidewalk, or driveway so
the edger guide line is above the desired line of cut.
5
| Categories | Lawn Mower Manual, MTD Lawn Mower Manuals, Troy-Bilt Lawn Mower Manuals |
|---|---|
| Tags | MTD Troy-Bilt TB144 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Lawn Mower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)