MTD Cub Cadet 521E Snow Blower Owners Manual

Lift the control handle up, and hook the Z end of
the control cable into the bottom hole in the control
handle, from the outside to the inside . If necessary,
pull up on the end of the cable with a pair of pliers to
obtain slack in order to hook it into the control
handle. Hold the Z fitting with the pliers, not the
cable, to avoid damaging the cable.
Secure eyebolt with 5/16 saddle washer and hex
nut. The cupped side of washer goes against the
handle. Adjust lower hex nut until the eyebolt is
positioned so that the chute crank turns freely
(does not bind).
Move upper hex nut down against the lower handle.
Tighten lower hex nut securely.
NOTE: The upper hole  in the control handle   provides
for adjustment in belt tension. Refer to page 9 of this
manual for instructions.
Assembling Discharge Chute
The snow thrower has been shipped with the upper
chute pivoted all the way down. Assemble as follows:  
Installing Chute Crank
Turn the chute crank until the chute faces straight
to the front. See Figure 7 .
Thread one 5/16 hex nut half way onto the eyebolt.
See Figure 5. All necessary hardware is included in
the hardware pack shipped with your unit. See  
Figure 2 for more details.
Flat
Washer
Hand
Knob
Carriage
Bolt
Slide the eyebolt onto the chute crank. Insert
eyebolt into the hole in the lower handle.
Chute Crank
Front
Eye Bolt
Hex
Upper
Chute
Nuts
Saddle
Washer
Figure 7
Remove the hand knob, flat washer and carriage
bolt from the upper chute. See Figure 7.
Pivot the upper chute up so that there is no gap
between the upper and the lower chute. See Figure
8. Secure with hardware just removed.
Figure 5
Insert the chute crank into the coupler at the top
right side of the snow thrower. See Figure 6.
Rotate the crank to align holes, and insert the cotter
pin. Bend ends of cotter pin in opposite directions to
secure. See Figure 6.
Cotter Pin
No
Gap
Chute Crank
Coupler
Pivot
the upper
chute
Figure 6
Figure 8
6
Product Specification
CategoriesCub Cadet Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals
Tags, ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 20 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website