2007 Kia Rondo Owners Manual

What to do in an emergency
10.
To reinstall  the wheel,  hold it on
the studs,  put the wheel  nuts on
the studs and tighten them finger
tight.The nuts should be installed
with their tapered small  diameter
ends directed  inward. Jiggle  the
tire  to  be  sure  it  is  completely
seated, then  tighten the  nuts as
much  as possible  with  your  fin-
gers again.
WARNING
Wheels  and wheel  covers  may
have sharp edges. Handle them
carefully    to    avoid    possible
severe injury. Before putting the
wheel  into  place, be  sure  that
there is  nothing  on the  hub or
wheel (such as mud, tar, gravel,
etc.)   that  interferes    with  the
wheel
from
fitting
solidly
11.
Lower  the car  to  the ground  by
turning   the  wheel   nut  wrench
counterclockwise.
against the hub.
OUN046019
If there  is, remove it.  If there is
not good contact on the mount-
ing  surface between  the wheel
and  hub, the  wheel nuts  could
come loose  and cause the loss
of a wheel. Loss of a wheel may
result  in loss  of  control of  the
vehicle.This  may cause serious
injury or death.
Then position  the wrench  as shown
in the drawing and  tighten the wheel
nuts.  Be sure  the  socket  is  seated
completely over the nut. Do not stand
on  the   wrench  handle  or   use  an
extension pipe over the wrench  han-
dle. Go around  the wheel  tightening
every other nut until they are all tight.
Then   double-check   each   nut   for
tightness.   After  changing   wheels,
have an authorized  KIA dealer tight-
en  the  wheel  nuts   to  their  proper
torque as soon as possible.
Wheel nut tightening torque:
Steel wheel & aluminum alloy wheel:
9~11
kg.m (65~79 lb.ft)
6
12
Product Specification
CategoriesKia Manuals, Kia Rondo Manuals
Model Year2007
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 343 pages
Document File TypePDF
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field