Features of your vehicle
This device complies with Industry
Canada standard RSS-210.
Operation is subject to the following two
conditions:
D010301AUN-EC
Limp home (override) procedure
4. If all of the digits have been input suc-
cessfully, you have to start the engine
within 30 seconds. If you attempt to
start the engine after 30 seconds, the
engine will not start and you will have
to input your password again.
After performing the limp home proce-
dure, you have to see an authorized KIA
dealer immediately to inspect and repair
your ignition key or immobilizer system.
When you turn the ignition switch to the
ON position, if the immobilizer indicator
1.
This device may not cause harmful
interference, and
(
) goes off after blinking 5 times,
your transponder equipped in the ignition
key is out of order. You cannot start the
engine without the lime home procedure.
To start the engine, you have to input
your password by using the ignition
switch.
2.
This device must accept any interfer-
ence received, including interference
that may cause undesired operation.
WARNING
The following procedure is how to input
your password of “2345” as an example.
Changes or modifications not
expressly approved by the party
responsible for compliance could
void the user's authority to operate
the equipment.
1.
Turn the ignition switch to the ON posi-
tion. The immobilizer indicator (
)
will blink 5 times and go off indicating
the beginning of the limp home proce-
dure.
2.
3.
Turn the ignition switch to the ACC
position.
To enter the first digit (in this example
“2”),
turn the ignition switch to the ON
and ACC position twice. Perform the
same procedure for the next digits
between 3 seconds and 10 seconds
(for example, for “3”, turn the ignition
ON and ACC 3 times).
4
5
| Categories | Kia Manuals, Kia Rondo Manuals |
|---|---|
| Model Year | 2007 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)