Attaching Beam
Engine
Mounting
Bracket
Hex
Nuts
•
For shipping purposes, the pressure hose is
attached to the pump on the engine and to the
control valve on the cylinder.
•
•
Disconnect the pressure hose from the adapter on
the pump.
Stand the wedge, beam, and cylinder assembly
upright with cylinder toward the top. An assistant
may be helpful.
Reservoir
Tank
•
•
Remove cotter pin and clevis pin from welded
brackets on beam assembly and move the
reservoir tank assembly in position against the
beam.
Insert clevis pin just removed through brackets on
beam and reservoir tank assembly. Secure with
cotter pin by bending the ends of the pin in opposite
directions.
Lock
Pump
Facing
Out
Washer
Hex
Bolts
Figure 8
Attaching The Hoses
Suction Hose
Cotter
Pin
•
The suction is attached to the reservoir tank,
beneath the engine mounting bracket. Loosen the
hose clamp on the free end of the hose. Remove
any protective insert from the end of the hose. See
Figure 9.
Clevis
Brackets
Pin
Pressure
Hose
Attached
To Engine
Attached To
Pump
Reservoir Tank
Hose
Reservoir
Tank
Clamp
Suction Hose
Figure 7
Figure 9
•
Remove the protective cap from the fitting on the
bottom of the pump (some oil may flow from pump).
Attach the end of the suction hose to the fitting on
the bottom of the pump. Place the hose clamp at
the base of the fitting and tighten securely.
Attaching Engine-Pump Assembly
•
Place the engine and pump assembly in position on
the engine mounting bracket with the pump facing
out. See Figure 8.
•
•
Align holes in base of engine with appropriate holes
in engine mounting bracket.
Secure the engine and pump assembly with four
hex bolts, lock washers, and hex nuts packed with
the Operator’s Manual.
Pressure Hose
•
The pressure hose is attached to the control valve.
Route the hose between the beam and the tongue.
Secure the pressure hose to the adapter on the top
of the pump. See Figure 9.
Return Hose
•
Secure with lock washers and hex nuts. Tighten to
14 ft-lbs.
•
The return hose is attached to the top of the control
valve. Loosen the hose clamp on the free end of the
hose. Cut the securing strap. Remove any
protective insert from the end of the hose.
7
| Categories | Lawn Mower Manual, MTD Lawn Mower Manuals, Troy-Bilt Lawn Mower Manuals |
|---|---|
| Tags | MTD LS338, Troy-Bilt LS338 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Lawn Mower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)
purchased a LS33TB from Lowe’s in Joplin. Received operator manual which stated engine manual was a separate item. However engine manual was not in pkg. Please advise as to how I may obtain engine manual. Thank you
Owen Johnson