8.
9.
Reinstall the two fasteners on top of the headlamp
assembly.
Front Turn Signal and Fog Lamps
To replace the front turn signal and/or fog lamp bulb(s),
do the following:
Reinstall the screw at the lower inboard side of the
headlamp assembly through the hole in the bracket
into the headlamp.
1. Remove the protection shield located on the
underside of the front of the vehicle by pulling out the
push-pins located on the underside of the shield. If
you are replacing a bulb on the passenger’s side,
also use a tool to remove the fasteners that attach
the front fascia extension panel in the wheelhouse.
10.
Reinstall the fasteners along the top surface of the
front fascia.
To replace the sidemarker and/or parking lamp bulb(s),
do the following:
1.
2.
3.
Turn the bulb socket counterclockwise to remove it
from the assembly.
2.
Remove the two screws located on the inboard side
and bottom of the lamp assembly that attach the
lamp assembly to the front fascia.
Replace the bulb. See Replacement Bulbs on
page 5-55 for the proper bulb number.
3.
Remove the lamp assembly from the front fascia by
rotating the lamp assembly rearward to disengage
the outboard hooks of the lamp from the slots
in the front fascia.
To reinstall the headlamp assembly, reverse Steps
5
through 10 of the procedure listed previously.
4.
5.
Disconnect the electrical harness connector from
the back side of the lamp assembly.
Remove the six Torx screws located on the
®
access cap.
5-53
| Categories | Cadillac Manuals, Cadillac SRX Manuals |
|---|---|
| Tags | Cadillac SRX 3.6, Cadillac SRX 4.6 |
| Model Year | 2004 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)