Back-Up and License Plate Lamps
7. Replace the bulb. See Replacement Bulbs on
page 5-55 for the proper bulb number.
To replace the back-up and/or license plate lamps,
use the following procedure:
8.
Reverse Steps 1 through 6 to reinstall the license
plate applique assembly.
1.
2.
Open the liftgate.
Replacement Bulbs
Remove the liftgate trim panel on the interior of the
liftgate by pulling the trim panel snap-in fasteners
out of the retainers and also by using a tool to
remove the screw on the bottom right side of the
trim panel.
For any bulb not listed here contact your dealer.
Exterior Lamp
Back-Up Lamp
Bulb Number
3157KX
9145
3.
4.
5.
Disconnect the courtesy lamp electrical connector
on the trim panel.
Fog Lamp
Use a tool to remove the five nuts on the back of
the license plate applique assembly.
Front Sidemarker
W5WLL
GM Part No.
10319395
Front Turn Signal Lamp/DRL
Remove the license plate applique assembly from
the liftgate by pulling the assembly rearward to
disengage the two snap-in retainer clips at the back
of the license plate applique assembly near the
liftgate panel.
Headlamp High-Beam
Headlamp Low-Beam
Parking Lamp
9005XS LL
9006XS LL
6.
For the back-up lamp, turn the bulb socket
one-quarter turn counterclockwise to remove.
With Halogen Low Beam
With HID Low Beam
W5WLL
For the license lamp, slide the license lamp
assembly out of the license plate applique
assembly, and turn the bulb socket one-quarter
turn counterclockwise to remove.
W5W B50X2
5-55
| Categories | Cadillac Manuals, Cadillac SRX Manuals |
|---|---|
| Tags | Cadillac SRX 3.6, Cadillac SRX 4.6 |
| Model Year | 2004 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)