MTD Cub Cadet 1333S WE Snow Blower Owners Manual

SECTION 4:  SET-UP INSTRUCTIONS
AUGER SHEAR BOLTS
Shear Bolts
The augers are secured to the auger shaft with two shear bolts
and hex lock nuts. If you hit a foreign object or ice jam, the snow
thrower is designed so that the bolts will shear. Two replacement
shear bolts and nuts are provided for your convenience. Store in a
safe place until needed
5/16-18 x 1-1/2" Long
(710-0890A)
Hex Lock Nuts
5/16-18 Thread
(712-0429)
NOTE: Reference to right or left side of the snow
thrower  is  from   behind  the  unit  in   the  operating
position.
IMPORTANT: Check
the
adjustments
as
instructed    on    page   6,    and    make    any   final
adjustments necessary before   operating your  snow
thrower. Failure to follow the instructions may cause
damage to the snow thrower.
1.
Remove screws  from the top sides and  ends of
the shipping crate.
2.
Set top, side, and end panels aside to avoid tire
punctures or personal injury.
Wing Nuts,
Washers
and Bolts
3.   Remove and discard plastic bag that covers unit.
4.
Roll unit out of crate.
Figure 3  
5.   Remove the lower two plastic wing nuts, cupped
washers and carriage bolts from each side of the
upper handle. See Figure 3.
6.
The chute directional control may be attached to
the  lower  handle  with   cable  ties  for  shipping
purposes,  if  so,  cut  the  cable  ties  and  remove
the chute directional control at this time.
7.
8.
Raise  the  upper  handle  assembly  until  it  locks
over the lower handle. See Figure 3 and Figure 4.
Wing
Nut,
Secure the  upper handle and lower handle with
the two plastic wing nuts, cupped washers and
carriage bolts previously removed. See Figure 4.
Washer
and
Bolt
9.
Slide the shift rod connector down over the end
of  the  lower  shift  rod.  See  Figure  5.  Tap  the
connector until it locks on the lower shift rod.
Figure 4  
NOTE: If the connector is not properly assembled,
the shift rod will pivot and you will not be able to shift
gears or change directions.
Upper Chute
Directional
Control
Upper Shift
Rod
10. Remove   the  hairpin  clip  from  the  end  of  the
upper chute directional control. Slide the upper
chute  directional  control   into  the  lower  chute
directional  control.  Align  the  holes,  and  secure
with hairpin clip. See Figure 5.
Connector
Hairpin
Clip
Lower
Shift Rod
Lower
Chute
Directional
Control
Figure 5  
5
Product Specification
CategoriesCub Cadet Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals
Tags, ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 24 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website