MTD Cub Cadet 826 4×4 Snow Blower Owners Manual

Reassemble new friction wheel rubber to the
friction wheel assembly, tightening the six screws in
rotation and with equal force.
Insert the pin from the shift arm assembly into the
friction wheel assembly and hold assembly in
position. Refer to Figure 18.  
Slide the gear shaft through the left side of the
housing and through the friction wheel assembly.
Insert the gear shaft through the sprocket and the
spacer. Make certain that the chain engages both
the large and the small sprocket.
WARNING:  Drain  fuel  into   an  approved
container  outdoors,  away  from  an  open
flame.  Allow  engine  to  cool.  Extinguish
cigarettes,    cigars,    pipes,     and    other
sources of ignition prior to draining fuel.
Fuel  left  in  engine  for  extended  periods
deteriorates    and    will    cause    starting
problems.
If unit is to be stored over 30 days, prepare for storage
as follows:
Remove gasoline from carburetor and fuel tank to
prevent gum deposits from forming on these parts
and causing possible malfunction of engine.
Run engine until fuel tank is empty and engine
stops due to lack of fuel.
Refer to Figure 18.
NOTE: If the sprocket fell from the snow thrower while
removing the hex shaft, place the sprocket on the hex
shaft. Position the hex hub of the sprocket toward the
friction wheel when sliding the sprocket on   to the hex
shaft.
Drain carburetor by pressing upward on bowl drain,
located below the carburetor cover.
Align the gear shaft with the right hand bearing and
carefully guide the left hand bearing into the left
side of the housing.
Reassemble the drive cover with the four screws
that were previously removed.
NOTE:  Fuel  stabilizer  is  an  acceptable  alternative  in
minimizing  the  formation  of  fuel  gum  deposits  during
storage. Do not drain carburetor if using fuel stabilizer.
Wipe equipment with an oiled rag to prevent rust.
Remove spark plug and pour one ounce of engine
oil through spark plug hole into cylinder. Cover
spark plug hole with rag. Crank engine several
times to distribute oil. Replace spark plug.
Follow the lubrication recommendations found in
the Maintenance Section.
NOTE:  If  you  placed  plastic  under  the  gas  cap,  be
certain to remove it.
Off-season Storage
WARNING:  Never  store   the  machine  or
fuel  container  indoors  where  there  is  an
open flame, spark, or pilot light such as on
water  heater,  furnace,  clothes   dryer,  or
other gas appliance.
Always store the snow thrower in a clean, dry area.
NOTE: When storing any type   of power equipment  in
an unventilated or metal storage shed, care should be
taken to rust proof the equipment. Using a light oil or
silicone,  coat  the  equipment,  especially  any  chains,
springs, bearings and cables.
15
Product Specification
CategoriesCub Cadet Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals
Tags, ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 28 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website