Wheel Steering Controls
the Open (vertical) position before attempting to start
the engine.
The left and right wheel steering controls are located on
the underside of the handles and are used to assist in
steering the snow thrower. See Figure 7. Squeeze the
right wheel steering control when turning right, squeeze
the left control when turning left. Operate your snow
thrower in open areas until you become familiar with
these controls.
Primer
Switch
Box
Choke
NOTE: It is easier to maneuver a non-running snow
thrower with both wheel steering controls held in
simultaneously.
Heated Handles Switch
Electric
Starter
Button
Ignition
Key
The heated handles switch is located on the right side
of the snow thrower handle panel. See Figure 7. To
activate the heated handles, toggle the switch to the
right to generate heat within the handles.
Recoil
Starter
Handle
Throttle
Control
NOTE: The heated handles are a compliment, NOT a
substitute for proper cold weather outerwear for hands.
It is recommended that the user wear gloves/mittens
when operating this snow thrower.
Figure 8
Headlight
The headlight is on whenever the engine is running.
IMPORTANT: Toggle the heated handles switch to the
left into the OFF position after using the snow thrower.
Throttle Control
Chute Tilt Control
The throttle control is located on the engine. It regulates
the speed of the engine and will shut off the engine
when pushed down completely. See Figure 8.
The distance snow is thrown can be changed by
adjusting the angle of the chute assembly. Move the
chute tilt control forward to decrease the distance,
toward the rear to increase. See Figure 7.
Safety Ignition Key
Fuel Shut-Off Valve
Closed
The safety ignition key must be fully inserted in the
switch before the unit will start. Remove the ignition key
when the snow thrower is not in use. See Figure 8.
The fuel shut-off valve, located under
the fuel tank, controls fuel flow from
the tank. Always make certain it is in
Open
IMPORTANT: Do NOT attempt to turn the key.
SECTION5: OPERATINGYOURSNOWTHROWER
Gas And Oil Fill-Up
Electric Starter
IMPORTANT: Although your snow thrower comes
shipped with oil already in the engine, you MUST check
the engine oil level as instructed in the separate engine
manual packed with your unit BEFORE starting the
engine for the first time. Read instructions carefully.
WARNING:
equipped with a three-wire power cord
and plug, and is designed to operate on
120 volt AC household current. It must be properly
grounded at all times to avoid the possibility of
electric shock which may cause injury to the
The
electric
starter
is
Service the engine with gasoline and oil as
instructed in the separate engine manual packed with
your snow thrower. Read instructions carefully.
operator.
Follow
all
instructions
carefully.
Determine that your house wiring is a three-wire
grounded system. Ask a licensed electrician if you
are not certain. If your house wiring system is not a
three-wire grounded system, do not use this
electric starter under any conditions. If your system
WARNING: Never fill fuel tank indoors,
with the engine running or while engine is
hot. Do not smoke when filling fuel tank.
8
| Categories | Cub Cadet Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Cub Cadet 1130 SWE, Cub Cadet 826 SWE, MTD 1130 SWE, MTD 826 SWE, MTD Snow Blower Manual |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)