Seat Adjustment
WARNING: Before operating this machine,
make sure the seat adjustment knobs are
tight to prevent any movement of the seat
while in operation.
Flip the seat up as shown in Fig. 5-3.
. Ltheooseat.sen thSeee twFig.o se5-3.at adjustment knobs located under
Adjusting
Your Lawn
Tractor
1.
2
3.
Slide the seat forward or rearward, then tighten the
knobs to lock the seat at the desired position. Put the
seat down to the operating position.
Steering Adjustment
If the tractor turns tighter in one direction than the other,
or if the ball joints are being replaced due to damage or
wear, the steering drag links may need to be adjusted.
Aintodjuthest thballe drjointag linonkstheso leftthatandequrightal lenside:gths are threaded
Figure -3
WARNING
1.
Loosenof the ballthejoint.jam Seenut foundFig. 5-4.on the drag link at the rear
Remove hex nut on the top of ball joint. See Fig. 5-4.
Before operating this
machine, make sure
the seat adjustment
knobs are tight to
prevent any movement
of the seat while in
operation.
2.
3
. Thread the ball joint toward the jam nut to shorten the
drag link. Thread the ball joint away from the jam nut
to lengthen the drag link.
4.
Replace hex nut and retighten the jam nut after proper
adjustment is achieved.
(EX�.UT
NOTE: Threading the ball joints too far onto the drag links
will cause the front tires to “toe-in” too far. Proper toe-in is
between 1/16” and 5/16”.
$RAG�,INK
Front tire toe-in can be measured as follows:
1.
Placetravel.the steering wheel in position for straight ahead
"
ALL�
*AM�
.UT
*
OINT
2.
In front of the axle, measure the distance horizontally
from the inside of the left rim to the inside of the right
rim. Note the distance.
Figure -4
NOTE: Threading the
ball joints too far onto
the drag links will cause
the front tires to “toe-in”
too far. Proper toe-in
is between 1/16” and
5/16”.
3.
4.
Behind the axle, measure the distance horizontally
from the inside of the left rim to the inside of the right
rim. Note the distance.
The measurement taken in front of the axle should be
between 1/16” and 5/16” less than the measurement
taken behind the axle. Adjust if necessary.
19
| Categories | Lawn Mower Manual, MTD Lawn Mower Manuals, Troy-Bilt Lawn Mower Manuals |
|---|---|
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Lawn Mower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)