MTD White Outdoor SB45 SB55 Snow Blower Owners Manual

SECTION4:  OPERATINGYOURSNOWTHROWER
Fuel and oil mixture
Release the auger control handle to stop the snow
throwing action and the forward motion.
WARNING:   Handle    gasoline   carefully;
remember   that  it   is  highly   flammable.
Never fill fuel tank indoors, when engine is
running or while engine is still hot. Do not
smoke when filling fuel tank.
Press auger
control handle
to engage
auger
Your  snow  thrower  uses   a  two  cycle  engine  that
requires a mixture of gasoline and two cycle engine
oil. Refer to the engine operator’s manual    for proper
oil and fuel recommendations.
Turn handle
to change
discharge
direction
A plastic cup was provided inside the fuel fill
opening on the fuel tank. Remove and discard this
cup before filling up the tank. Use the seperate
fuel tank cap to close after fill-up.
Starting engine
Figure 11
To start the engine of your snow thrower, follow
the starting instructions in the engine operator’s
manual.
Stopping engine
Run the engine for a few minutes before stopping
to help dry up any moisture on the engine.
Turn ignition key to OFF position and remove it
from the snow thrower.
Operating snowthrower
Loosen hand knobs on two sides and adjust the
upper discharge chute up or down as shown in
Figure 10. Then use the chute crank to position
the entire discharge chute in order to discharge
IMPORTANT: Keep the ignition key in a safe place.
Engine will not start without it.
Wipe all snow and moisture from the unit. Move
the choke lever back and forth several times and
leave it in the ON position.
snow with the wind.
Upper Discharge
Chute
Operating tips
For most efficient snow removal, remove snow
immediately after it falls.
Change
position by
chute crank
Discharge snow downwind whenever possible.
Slightly overlap each previously cleared path.
Lifting up on the handle will allow the rubber on the
augers to propel the snow thrower forward.
Pushing downward on the handle will raise the
augers off the ground and stop the forward motion.
Hand
Knob
NOTE: Excessive upward pressure on the handle will
result in premature wear on the   rubber auger blades
which will not be covered by warranty.
Figure 10
WARNING: Do not throw snow towards a
building as objects could be discharged
with enough force to cause damage.
Run the engine for a few minutes before stopping
to help dry any moisture on the engine.
Clean the snow thrower thoroughly after each use.
After making sure no bystanders or obstacles are
in front of the unit, engage the auger control
handle. See Figure 11. As the snow thrower starts
to move, maintain a firm hold on the handle, and
guide the snow thrower along the path to be
cleared.
WARNING:   Do  not   operate   this   snow
thrower  on  gravel  as   loose  gravel  can
easily  be  picked  up  and  thrown  by  the
auger,  causing  injury  to  people  around
and/or damage to the snow thrower.
8
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals, White Outdoor Snow Blower Manuals
Tags, , , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 20 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website