English
Winding Line onto Spool
Removing Remaining Nylon Line
Schnur/LINE
2
3
2
Schnur/LINE
1
1
2
3
5
N
N
Hold the mowing head steady.
N
N
Use green-coded nylon line with a
diameter of 0.08 in (2.0 mm).
Rotate the spool counterclockwise
until the shortest line is about 4 in
N
Open the mowing head – hold it
steady with one hand.
(10
cm).
Cut two 78 in (2 m) lengths of line
from the replacement reel (special
accessory).
N
N
Turn the cap (1) counterclockwise.
N
If necessary, cut the longer line to a
length of about 4 in (10 cm).
Disengage the spool (2), take it out
of the mowing head and remove the
remaining line.
N
N
Rotate the spool (2)
counterclockwise until the two arrow
points are in alignment.
The mowing head is now full.
Winding Line onto Spool
STIHL AutoCut 5-2
Push the straight end of each line
through one sleeve (5) in the
mowing head (3) until you feel a
noticeable resistance – and then
continue pushing as far as stop.
A prewound spool (special accessory)
may be used as an alternative to the
following procedure.
Always check the mowing head for signs
of wear before replacing the nylon line.
If there are signs of serious wear,
replace the parts concerned or
install a new mowing head.
Preparations
N
N
Shut off the engine.
Put the trimmer on the ground with
the mowing head facing up.
FS 40, FS 40 C, FS 50, FS 50 C
29
| Categories | Blower Vacuum and Sweeper Manuals, STIHL Trimmer Manuals, Trimmer Manuals |
|---|---|
| Tags | STIHL FS 40, STIHL FS 50 |
| Download File |
|
| Language | English, Español |
| Product Brand | STIHL. Stihl Inc, USA - Corporate phone: (757) 486-9100. International Support Information: http://stihl.com Email: info@stihl.com, Trimmer |
| Document File Type | |
| Publisher | stihl.com |
| Wikipedia's Page | Stihl |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)