MTD White Outdoor 616 Hydrostatic Tractor Lawn Mower Owners Manual


WARNING: Never attempt to make
any adjustments while the engine is
running, except where specified in
the operator’s manual.
Adjusting
Your Lawn
Tractor
Leveling the Deck
NOTE: Check the tractor’s tire pressure before performing
any deck leveling adjustments. Refer toTires  on page 24
for information regarding tire pressure.
Front To Rear
The front of the cutting deck is supported  by a stabilizer
bar that can adjusted to level the deck from front to
rear. The front of the deck should be between 1/4-inch
and  3/8-inch  lower than the rear of the deck. Adjust if
necessary as follows:
Loosen
Tighten
to lower deck
to raise deck
1.
With the tractor parked on a firm, level surface, place
the deck lift lever in the top notch (highest  position)
and rotate the blade nearest the discharge chute so
that it is parallel with the tractor.
Figure -1
WARNING
Never attempt to make
2.
Measure the distance from the front of the blade tip to
the ground and the rear of the blade tip to the ground.
The first measurement taken should be between 1/4”
and 3/8” less than the second measurement. Deter-
mine the approximate distance necessary for proper
adjustment and proceed, if necessary, to the next step.
From the front of the tractor, loosen the hex lock nut
on each end of the deck hanger rod, and turn away
from the inner hex nuts. See Fig. 5-1.
any adjustments
while the engine
is running, except
where specified in the
operator’s manual.
3.
4.
Never attempt to
adjust the brakes
while the engine
is running. Always
disengage PTO, move
shift lever into neutral
position, stop engine
and remove key to
prevent unintended
starting.
Tighten the inner hex nuts front against the front
hanger bracket to raise the front of the deck; loosen
the hex nuts to lower the front of the deck.
NOTE: Models with a 42-inch deck have only ONE jam
nut, washer, and lock nut.
5.
Retighten the two lock nuts against the inner hex nuts
when proper adjustment is achieved.
Adjustment Gear
Hex Bolt
Side to Side
If the cutting deck appears to be mowing  unevenly, a side
to side adjustment can be performed. Adjust  if necessary
as follows:
Figure -
1.
2.
3.
With the tractor parked on a firm, level surface, place
the deck lift lever in the top notch (highest  position)
and rotate both blades so that they are perpendicular
with the tractor.
Measure the distance from the outside of the left blade
tip to the ground and the distance from the outside of the
right blade tip to the ground. Both measurements taken
should be equal. If they’re not, proceed to the next step.
Loosen,left deckbuthangerdo NOTbracket.remove,SeetheFig.hex5-2.cap  bolt on the
0
Product Specification
CategoriesLawn Mower Manual, MTD Lawn Mower Manuals, White Outdoor Lawn Mower Manuals
Tags,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 64 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Lawn Mower
Product TypeWalk Behind Mower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website