Yard-Man 31AH553G401 Electric Snow Blower Owners Manual by MTD

Unhook the idler spring from the hex bolt on the
auger housing. See Figure 19.
Back out the stop bolt until the support bracket
rests on the auger pulley. See Figure 20.
Friction Wheel
NOTE: It may be necessary to loosen the six nuts that
connect the frame to the auger housing to aid in belt
removal.
Drive Plate
Drive Belt
Stop Bolt
Lift the rear auger belt from the auger pulley, and
slip belt between the support bracket and the auger
pulley. See Figure 19. Repeat this step for the front
auger belt.
Support Bracket
Figure 20
Changing Friction Wheel Rubber
The rubber on the friction wheel is subject to wear and
should be checked after 25 hours of operation, and
periodically thereafter. Replace the friction wheel
rubber if any signs of wear or cracking are found.
Support
Bracket
Rear
Auger
Belt
Frame
Drain the gasoline from the snow thrower, or place
a piece of plastic under the gas cap.Tip the snow
thrower up and forward, so that it rests on the
housing.
Front
Auger
Belt
Remove six self-tapping screws from the frame
cover underneath the snow thrower. See Figure 21.
Remove the click pins which secure the wheels,
and remove the wheels from the axle.
Auger
Pulley
Support
Bracket
Spring
Idler
Spring
Auger
Housing
Spacer
Friction
Wheel
Figure 19
Replace both auger drive belts by following
instructions in reverse order.
Hex
Shaft
NOTE: If you placed plastic film under the gas cap, be
certain to remove it before operating the snow thrower.
Drive Belt
Follow the first four steps of instructions to service
the auger belts.
Pull idler pulley up, and lift belt off engine pulley and
friction wheel disc. See Figure 18.
Back out the stop bolt until the support bracket
rests on the auger pulley. See Figure 20.
Slip belt between friction wheel and friction wheel
disc. See Figure 20. Remove and replace belt.
Reassemble the parts removed earlier.
Drive Shaft
Drive Cover
Self-Tapping
NOTE: The support bracket must rest on the stop bolt
Screws
after the new belt has been assembled. See Figure 20.
Self-Tapping
Screws
Figure 21
Remove the four screws securing the left drive
cover to the frame. Remove the drive cover.  See
Figure 21.
15
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals, Yard Man Snow Blower Manuals
Tags, ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 28 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandYard-Man, 31AH553G401, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website