Yard-Man 31AH553G401 Electric Snow Blower Owners Manual by MTD

SECTION 2:  ASSEMBLING YOUR SNOW THROWER
Unpacking
Remove screws from the top sides and ends of the
shipping crate.
Handle Panel
Set panel aside to avoid tire punctures or personal
injury.
Remove and discard plastic bag that covers unit.
Roll unit out of crate.
Check crate thoroughly for loose parts before
discarding.
Loose Parts
Upper Handle
The snow thrower is shipped with following loose
Wing Nuts,
parts in the carton. See Figure 1 for illustration,
description of item and part number. Please
remove all loose parts from the carton  before
discarding it.  
Washers
and Bolts
Figure 2
Shear Bolts
(710-0890A)
Raise the upper handle assembly in the direction
shown in Figure 2. Make sure that the upper handle
locks into position over the lower handle.
Upper
Handle
Hex Lock Nuts
(712-0429)
Carriage
Bolt
Tighten these
wing nuts
Figure 1
Please note that these shear bolts and hex lock
nuts are not meant for initial assembly of the
equipment. If the snow thrower hits a foreign object
or ice jam, the bolts, securing the auger shaft, may
shear. Use these two shear bolts and nuts as
replacement then. Store these in a safe place until
needed.
Wing
Nut
Cupped
Washer
IMPORTANT: NEVER replace the auger shear bolts with
standard hex bolts. Any damage to the auger gearbox
or other components from standard hex bolts will not be
covered by your snow thrower’s warranty.
Lower
Handle
Assembling Handle
NOTE: Reference to the left or   right side of the snow
thrower in this manual is observed from the operator’s
position.
Figure 3
Look at lower rear of snow thrower frame to be sure
all cables are aligned with cable roller guides.
Secure the upper handle and lower handle with the
two plastic wing nuts, cupped washers and carriage
bolts previously removed. Attach these hardware
on the lower hole in the handles. See Figure 3.
Tighten the two wing nuts already in place on the
upper holes and secure the handles firmly. See
Figure 3.
IMPORTANT: Make any final adjustments, as instructed
later on in this section, before operating your snow
thrower. Failure to follow these instructions may cause
damage to the snow thrower.
Remove the lower plastic wing nut, cupped washer
and carriage bolt from each side of the lower
handle. See Figure 2.
5
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals, Yard Man Snow Blower Manuals
Tags, ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 28 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandYard-Man, 31AH553G401, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website