Yard-Man 31AH553G401 Electric Snow Blower Owners Manual by MTD

Electric Chute-Rotation Switch
Skid Shoe
The electric chute-rotation switch is located on the left
side of the snow thrower handle panel.
To change the direction in which discharged snow is
thrown, proceed as follows:
The position of the skid shoe is determined by the
condition of the ground from where snow has to be
removed. Refer to page 7 for details.
Fuel Shut-off Valve
Push the toggle switch to the left to rotate the chute
counterclockwise.
Push the toggle switch to the right to rotate the
chute clockwise.
The fuel shut-off valve is located under the fuel tank.
This valve controls fuel flow from the tank. Always
make certain it is in the open (vertical) position before
attempting to start the engine. See Figure 10.
IMPORTANT: Release the switch once the chute has
completed its rotation cycle in either direction. Failure to
do so can result in damage to the electric chute motor
and/or its drive gear.
Headlight
The headlight is on whenever the engine is running.
Throttle Control
The throttle control is located on the engine. It regulates
the speed of the engine. See Figure 10.
Wheel Steering Controls
The left and right wheel steering controls are located on
the underside of the handles and are used to assist in
steering the snow thrower. Squeeze the right wheel
steering control when turning right; squeeze the left
control when turning left. Operate snow thrower in open
areas until you become familiar with these controls.
Safety Ignition Key
The safety ignition key must be fully inserted in the
switch before the unit will start. Remove key when snow
thrower is not in use. Do not attempt to turn the key.
See Figure 10.
Stay Warm Grips Switch
The Stay Warm grips switch is located on the right side
of the snow thrower handle panel. To activate the Stay
Warm grips, toggle the switch to the right to generate
heat within the handles. Toggle the switch to the left
into the OFF position after using the snow thrower.
Primer
Choke
NOTE: The Stay Warm grips are a compliment to, not a
substitute for, proper cold weather outerwear for hands.
It is recommended that the user wear adequate winter
protection    for   hands    (like    gloves/mittens)   when
operating this snow thrower.
Recoil
Starter
Handle
Chute Tilt Control
Safety
Ignition
Key
The distance snow is thrown can be changed by
adjusting the angle of the chute assembly. Move the
chute tilt control forward to decrease the distance,
toward the rear to increase.
Throttle
Control
Closed
Discharge Chute
Fuel Shut-Off
Valve
The angle of the discharge chute controls the distance
that the snow is thrown. Tilt the discharge chute up for
greater distance; tilt down for less distance.
Open
Figure 10
9
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals, Yard Man Snow Blower Manuals
Tags, ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 28 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandYard-Man, 31AH553G401, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website