6
Replacing Belt
WARNING: Before servicing, repairing,
or inspecting, disengage the control
bail and stop engine. Wait until all
moving parts have come to a complete
stop. Disconnect spark plug wire and
ground it against the engine to prevent
unintended starting.
������������
Adjustments
&
Remove the belt cover by removing five hex screws. See
Figure9. Thensimplypull thebelt off bygraspingit from
the bottom of the auger pulley and pulling off. Once you
remove the belt from the pulleys, you can push down on
the idler pulley to release the belt from under belt keeper.
To replace the belt follow these instructions and refer to
Figure 10:
Maintenance
�����������
������
�������������������
1.
2.
3.
Push down on the Idler pulley.
Put belt on top of the auger pulley under belt keeper.
Thread belt around engine pulley.
Figure 9
WARNING
4. Push belt over bottom of auger pulley.
Reinstall the belt cover removed earlier.
�
Beforeservicing,
�
repairing, orinspect-
ing, disengagethe
control bail andstop
engine. Wait until all
movingpartshave
cometoacomplete
stop. Disconnect
sparkplugwireand
groundit against the
enginetoprevent
Engine
1.
Refer to the separate engine manual for all engine
maintenance procedures.
2.
Check engine and snow thrower frequently for loose
hardware, and tighten as needed.
�
Lubrication
Lubricatepivot pointsonthecontrol handleandthe
extension spring at the end of the control cable with a
light oil once every season and before storage of the
snow thrower at the end of the season.
�
unintendedstarting.
Replacing Auger Paddles
The snow thrower auger’s rubber paddles are subject to
wear and should be replaced if any signs of excessive
wear is present.
Figure 10
IMPORTANT: Do NOT allow the auger’s rubber paddles
to wear to the point where portions of the metal auger
itself can come in contact with the pavement. Doing so
can result in serious damage to your snow thrower.
IMPORTANT: Do NOT
allow the auger’s rubber
paddles to wear to the point
where portions of the metal
auger itself can come in
contact with the pavement.
Doing so can result in
serious damage to your
snow thrower.
To change the rubber paddles, proceed as follows:
1.
Remove the existing rubber paddles by unthreading the
self-tapping screws which secure them to the auger.
See Figure 11.
2.
Secure the replacement rubber paddles to the auger
using the hardware removed earlier.
Figure 11
11
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | MTD 295, MTD 2B5, MTD E295, MTD E2B5, MTD Snow Blower Manual |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)