3
Snow
Thrower
Setup
WARNING: Disconnect thesparkplug
wireandgroundit against theengineto
prevent unintendedstarting.
�
Positioning the Upper Handle
Removepackingmaterial, if present.
1.
2.
Raisetheupper handleinthedirectionshownin
Figure1until it clicksintotheoperatingposition.
Makesurenot topinchor crimpthecable.
�
�
3.
Tightentheknobs.
Figure 1
Assembling the Discharge Chute
For shipping reasons, the snow thrower has been
packaged with the upper chute pivoted all the way down.
To pivot it upward, proceed as follows:
NOTE: This Operator’s
Manual covers several
models.
Not all features refer-
enced in this manual
are applicable to all
snow thrower models.
�
1.
Turn the chute until the chute opening is facing
straight ahead.
2.
Remove the knob and carriage bolt from the lower
chute. See Figure 2.
�
3. Pivot the upper chute upward over the lip on the lower
chute so that there is NO gap between the upper
chute and the lower chute.
�
4. Re-secure with the hardware just removed. If installed
correctly, your snow thrower should look like Figure 3.
�
NOTE: All references
to left or right side of
the snow thrower is
from the operating
positiononly.
IMPORTANT: Do not use the chute handle to lift the
snow thrower
Figure 2
������������
IMPORTANT:
Do not use the
chute handle to lift
the snow thrower.
Figure 3
6
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | MTD 295, MTD 2B5, MTD E295, MTD E2B5, MTD Snow Blower Manual |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)