UNDERSTANDINGTHEFEATURESOFYOURVEHICLE
147
If,afterprogrammingtheHomeLinkWirelessControl
SimilartothisCanadianlaw,someU.S.gateoperatorsare
System,
the
hand-held
transmitter
and/or
other
designedtoЉtime-outЉinthesamemanner.
HomeLink units in other vehicles fail to activate the
rollingcodeequippeddevice,youmayneedtoclear(or
If you live in Canada or you are having difficulties
programming a gate operator by using the ЉProgram-
ming HomeLinkЉ procedures (regardless of where you 3
live),replacesteptwowiththefollowing:
؆
erase
؆
) the device’s receiver memory. Refer to yourgarage door opener’s Owner’s Manual for the proce-
dure or contact HomeLink at 1-800-355-3515 or on the
Internet at www.homelink.com. After clearing the re-
ceiver, you must reprogram the original hand-held
transmitter(s)tothereceiverusingtheprocedureinthe
garage door opener’s Owner’s Manual. Finally, repro-
gram the hand-held transmitter(s) to HomeLink using
thestepsunder
؆
ProgrammingHomeLink؆
.NOTE: If programming a garage door opener or gate
operator, it is advised to unplug the device during the
ЉcyclingЉprocesstopreventpossibleoverheating.
PressandholdtheHomeLinkbuttonwhileyoupress
andrelease-everytwoseconds(
؆
cycle؆
)yourhand-heldtransmitter button until the radio signal has success-
fully been accepted by HomeLink. (The message
TRAINEDwillappearontheHomeLinkdisplay.)
GateOperator/CanadianProgramming
Canadian radio-frequency laws require transmitter sig-
nals to Љtime-outЉ (or quit) after several seconds of
transmission - which may not be long enough for
HomeLink to pick up the signal during programming.
Proceed with the remaining steps under ЉProgramming
HomeLinkЉtocomplete.
| Categories | Jeep Liberty Manuals, Jeep Manuals |
|---|---|
| Model Year | 2007 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)