2011 Evinrude 40 50 60 hp E-TEC RL TL PL SL Outboard Boat Motor Owners Manual

X OIL AND FUEL
FUEL SYSTEM INFORMATION
WARNING
Fuel Hose Connections
If the  fuel hose is  disconnected for  any rea-
son, seal it to prevent spillage. Cap the fuel fit-
ting to prevent contamination.
Connect the  fuel hose  to the 3/8  in. (9  mm)
fuel  fitting.  Fasten  fuel  hose  securely  with
hose clamp (18.5 mm) from owner’s kit.
If  engine is  equipped  with a quick-
disconnect   fuel  hose,   you   MUST
disconnect  the  fuel  hose  from  the
engine and the fuel tank to prevent
fuel leaks:
Squeeze fuel primer bulb, outlet end up, until
firm.
Whenever the engine is NOT being
used
Whenever the engine is being trail-
ered
Whenever the engine is in storage
NOTE: A small amount of fuel may
be released when the fuel connector
is disconnected.
1
Store portable fuel tanks in well-ven-
tilated    areas,    away     from    heat
sources and open flames. Close the
vent  screw  of  the  fuel  tank  cap,  if
equipped, to prevent escape of fuel
or fuel vapors which could acciden-
tally  ignite.   Do  not   allow  discon-
nected fuel hoses to leak fuel.
1.
Fuel hose and fitting – 3/8 in. (9 mm)
Fuel Connector
If equipped, disconnect fuel hose  connectors
from the engine’s fuel connector when the en-
IMPORTANT: Fuel  distribution hoses  in the    gine is not in use.
boat must deliver  fuel at a specific  flow rate.
Minimum inside diameter  of fuel hoses  must
be 5/16 in. (7.9 mm).
Fuel systems  with  built-in tanks,  particularly
those that include antisiphon valves and filter/
primer units, may have restrictions not  allow-
ing the engine  fuel pump to deliver  sufficient
fuel under all  conditions. This can result in  a
loss of  performance. If  a performance  prob-
lem exists, see your Dealer.
1
Fuel System Priming - Rope Start
Models
007004
1.
Fuel connector
If the outboard is run out of fuel, refill the fuel
tank and squeeze  the primer bulb  until firm.
Prime the electric fuel pump by first removing
the emergency stop switch clip and then pull-
ing the rope at least two times. This will cause
the fuel pump to fill the injectors. Replace the
emergency  stop  switch clip  and  follow  the
normal starting procedure.
23
Product Specification
CategoriesBRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual
Tags, , , , , ,
Model Year2011
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 90 pages
Document File TypePDF
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website