X OPERATION
Move the remote control handle to NEU- Starting
TRAL.
Turn the key switch fully clockwise to the
START position.
WARNING
NOTICE
The starter motor can be dam-
If you are using a remote control
that does not have start-in-gear pre-
vention, the outboard can be started
while it is in gear. Protect against
unexpected boat movement by
always starting your outboard in
NEUTRAL.
aged if operated continuously for more
than 20 seconds.
WARNING
Always shift to NEUTRAL before
starting the outboard to prevent
sudden boat movement, which can
cause injury.
Set control to SLOWEST speed position.
Upon start-up, release the key.
If the engine did not start, release the key mo-
mentarily, then try again.
1
Each time the key switch is turned from OFF
to ON, the warning system will self-test. Refer
to Engine Monitoring on page 44. If the
warning system fails to self-test during start-
up, see your Dealer.
If your outboard does not react normally to
this starting procedure or if it fails to start, re-
fer to Troubleshooting on page 60.
007071
1.
SLOWEST speed position
DO NOT advance the throttle before start-up.
Advancing the throttle overrides the electron-
ic idle control system. After the engine starts,
the engine management module (EMM) au-
tomatically increases idle speed slightly. Idle
speed will decrease as the engine warms up.
The engine monitor gauge lights or display
will illuminate if the throttle is advanced.
31
| Categories | BRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual |
|---|---|
| Tags | Evinrude 40 hp, Evinrude 50 hp, Evinrude 60 hp, Evinrude PL, Evinrude RL, Evinrude SL, Evinrude TL |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)