Using Your Evinrude E-TEC Outboard
Starting
Engine Stopping
While seated, grasp the starter handle and Twist the throttle grip to SHIFT position or
pull slowly until the starter engages, then pull
hard. Repeat, if needed, until outboard starts.
slower.
Move shift lever to NEUTRAL.
Press the STOP button until the outboard
stops running. If equipped, close the vent
screw on the fuel tank’s filler cap.
NOTICE
assembly, allow starter cord to rewind be-
fore releasing starter handle.
To prevent damage to starter
1
2
1
1.
STOP button
1.
2.
Starter handle
NEUTRAL
IMPORTANT: Engine will not start if outboard
is in gear or if lanyard is not in place.
If your outboard does not react normally to
this starting procedure or if it fails to start, re-
fer to Troubleshooting on page 60.
After Engine Starts
Check the water pump indicator. A steady
stream of water indicates the water pump is
working. If a steady stream of water from the
water pump indicator is not visible, stop the
engine. Refer to Engine Overheating on
page 46.
26
| Categories | BRP Brand Manuals, Evinrude Brand Manuals, Evinrude E-TEC Manual, Evinrude Outboard Manual |
|---|---|
| Tags | Evinrude 40 hp, Evinrude 50 hp, Evinrude 60 hp, Evinrude PL, Evinrude RL, Evinrude SL, Evinrude TL |
| Model Year | 2011 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)