STARTING AND OPERATING
295
N
NOTE: The “SERV 4WD” warning light monitors the
electric shift 4WD system . If this light rem ains on after
engine start up, or it illuminates during driving, it means
that the 4WD system is not functioning prop erly and that
service is requ ired .
Neutral - Disengages both the front driveshaft and rear
driveshaft from the powertrain. To be used for flat
tow ing behind another vehicle. Refer to “Recreational
Towing” in this section for more inform ation.
Transfer Case Position Indicator Ligh ts
Shiftin g Proced ures
The 4WD ind icator lights are located in the instru ment
cluster. The “N” (Neutral) ind icator light is located on the
NOTE: If any of the requ irem ents to select a new
4WD Control Switch. If there is no ind icator light on or transfer case position have not been met, the transfer case 5
will not shift, the ind icator light for the previou s position
flashing, the transfer case position is 2-wheel drive
will rem ain ON, and the new ly selected position ind ica-
(2WD).
(4WD
If the ind icator light is on, the desired position
LOCK, 4WD LOW, or NEUTRAL) has been ob-
tor light will continu e to flash until all the requ irem ents
for the selected position have been met. To retry a shift,
move the 4WD Control Switch back to the original
position, make certain all shift requ irem ents have been
met, wait five (5) second s, and try the shift again.
tained .
If One or More Shift Requirement s are not met:
•
•
An ind icator light will flash.
The transfer case will not shift.
| Categories | Jeep Liberty Manuals, Jeep Manuals |
|---|---|
| Model Year | 2008 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)